Posted by fixerupper on January 06, 2022 at 06:06:12 from (100.42.82.64):
In Reply to: LED pole barn light posted by Geo-TH,In on January 06, 2022 at 03:57:51:
Here is a 1000 watt equivalent corn cob sandwiched into an old stadium light. This light has been on my shop forever but the old mogul based bulb just didn't put out much light compared to the LED yard light I have on a pole not far away. I have adaptors to adapt a small based bulb to mogul but the mogul base was recessed too far up into the fixture to get the corn cob to work. I took the light apart and replaced the mogul base with a regular small base and this is what it turned out to be. It is too bright to look at when it is on at night. It is many times brighter than a 1000 watt mogul based incandescent that would be the size of a volleyball and would make the light meter spin at a dizzying speed. This light is controlled by a switch inside the shop, no photo eye. I still have my fingers crossed on the pole mounted LED yard lights I have on the farm but so far they have held up very well.
This post was edited by fixerupper on 01/06/2022 at 06:07 am.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
