You can call me the woodstove Barney if you like I am only pointing out a few things I am observing in your post, you can consider or ignore them as you please.
I have installed 4 woodstoves and chimneys over the years and they all passed inspection, I am not a professional installer but I do have experience with the process.
-As has been pointed out the height of your chimney is not adequate, it needs to be a minimum of 3 feet.
This is in part for proper draft but also to reduce the chance of lighting your roof on fire should a chimney fire occur.
-I can not tell from the photo what you are using for floor protection, if it is ceramic tile that is not considered adequate, additionally here anyways it must be at least 18 inches in front of the stove.
-Your side wall clearance looks a little close it is hard to tell from the picture, it might require an additional heat shield.
-Assuming you have insurance on your house if you do not notify the insurance company that you have installed a wood fueled appliance you will be out of luck if you ever have to make a fire claim.
-To have them inspected there was no charge and it did not take them long, just some measurements and pictures that they send in for approval, usually completed in a day or two.
-One stove I installed in a shop they had a concern with clearance due to a low ceiling, all that took to rectify was a piece of sheet metal with spacers behind it to bring it up to code.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oliver 550 Purchaser Checklist - by Greg Sheppard. Pound for pound the 550 is better than anything I've seen. It has great power for its size and can really hunker down and lug. Classified as a 3-bottom plow depending on soil conditions. I personally don't think it can be beat for a utility tractor in the 40 HP range. They are extremely thrifty on fuel, at least my DSL is. Most drive train parts are fairly easy to get. Sheet metal is probably the hardest thing to
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
