Quote: CVPost-redforlife (quoted from post at 20:13:13 01/25/22) No difference if both front ends are fixed. But, I will say this. A wide front end that swivels (one front wheel goes up when the other goes down), shouldn't be compared to a narrow front that is fixed and doesn't do that. Because, it's just not the same. Not sure if your familiar with a roll-amatic front end. They allowed for some movement to keep the weight equally on both wheels. Without it, the front end is just fixed other than turning. Well, a wide front that swivels gives you the same affect as a roll-amatic narrow front.
Being fixed or not would be the only difference. And not fixed would be better. Otherwise the possibility is there for entire weight being only on one wheel.
For rollover, major difference is height of tipping point.
Rollomatic pivots at ground level, so tractor stands on a triangle formed by rear wheels and narrow front and at ground level. Anytime the weight direction moves outside the triangle, tractor tips over. Shift of weight direction can be due to a slope, ateral acceleration and braking. Front loader make it very easy to do, because weight is shifted to the front and higher, so a small angle can make the weight go out of the safety triangle.
On a wide front, tractor stands on a triangle formed by the rear wheel and the front axle pivot. Only the rear edge of the triangle is on the ground.
The higher the pivot, the better.
This post was edited by fdt860 on 01/25/2022 at 08:52 pm.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.