Posted by John Deere D on February 18, 2022 at 08:58:30 from (199.66.170.5):
Good day... We (my wife and I) are going to install a 2000 Ford V-10 engine from a 2000 Motorhome (20,000 Miles Motor Home was broad sided on Passengers side) into our utility Truck.. 1999 F-250 Super duty, V-10 2 WD Auto, club cab ,short box.
My concern is... The 2000 V-10 Engine NEVER had an Exhaust recirculating tube from the left exhaust manifold. The inner Intake housing is a PLASATIC/something composite construction.
The 1999 V-10 Engine has an Aluminum inner Intake manifold and an Exhaust recirculating tube from the left exhaust manifold.
I have purchased all of the GASKETS so as we can swap the two Intake manifolds and left exhaust manifold.
I'm concerned that if we do not do the Manifold swaps, the Exhaust gases may deteriorate the Plastic /composite inner intake manifold.
Manifold pics off Intrnet. I'm quite aware that the entire fuel RAIL assembly/Injectors fuel pressure reg. shall be swapped from the 2000 to the 1999
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
