Posted by BarnyardEngineering on February 22, 2022 at 11:20:23 from (161.69.121.34):
In Reply to: No Shortage posted by john in la on February 22, 2022 at 07:14:09:
redforlife, you go to all that effort of explaining how the supply chain works and then you go and completely ignore it as you appear to accuse the other processors of price gouging.
The processing is an integral part of the... process, I guess. You have live cows on one end and meat on styrofoam trays on the other. When the processing capacity is reduced significantly, and demand stays the same, you end up with a shortage of processed meat and a surplus of live animals.
Sure there is no shortage of beef... ON THE HOOF. Fat lot of good that does the average consumer who thinks beef comes from the grocery store. To put it another way, you can't just bite a hunk off of a cow and eat it.
The shortage is in PROCESSED beef, and it's due to a bottleneck in the processing not necessarily a shortage of raw materials. Simple supply and demand economics apply here. When the supply goes down the price goes up. Demand does not have to go up. The meat processing plants are going full bore but they can't keep up with normal demand, that necessitates an increase in price of the finshed product to curtail demand some until, or instead of, bringing more processing online.
On the other side of the coin, there are now too many live cows because the processers can't kill them fast enough. Again, simple supply and demand economics. Demand has dropped because that plant burned, and even though there are the same number of cows available, that is, supply has not changed, the price has to go down due to reduced demand.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
