Looks like a fairly heavy blade. Heavy enough that it'll likely have to much force on the top link to adjust the top link while being hooked up to blade. Disconnect top link, adjust it to the length you want (guess), and hook it back up to the blade already adjusted. Note, (you will need to use the 3 point lever on tractor to raise/lower the blade to get the top link hooked back up). If pre-adjusted top link is to long to hook up, raise the three point a little. If top link is to short, lower the three point a little. To take some of the trial and error of the guessing game out if it, with top link removed, adjust blade to the angle you want with three point lever, and adjust top link to that length as close as you can get, then hook it back up as previously mentioned. The top link has two threaded pieces. One on each end. Note, that the ends are designed to be adjusted simultaneously by turning the middle when hooked up. So when adjusting it while unhooked, make sure your adjusting it the same amount on both ends (count turns). These can get out of sink by only adjusting one end. If out if sink, your adjusting limitations will be all messed up. If it is all messed up already, you can turn both ends all the way in, and then back out seperately by same number of turns.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
