Posted by FerdferLife on February 25, 2022 at 12:26:35 from (46.246.122.103):
Hi People
I grew tired of everything slapping around on the 3 point, so i decided to buy a stabilizer kit. THis one;
The brackets on/under the axel fits fine, however on the end that i need to drill holes to attach the bars to the lift arms, im a bit confused. If i push the liftarms out all the way towards the wheels, the stabilizer bar all the way in, then mark it, raise the liftarms all the way up, the stabilizer bar wants to move inwards on the liftarms. With other words if they were locked and bolted in, they would be too short when i raise the liftarms.
Is this cuz im measuring where to drill the holes wrong? if so, any tips on how to go about getting it right?
Also when i do the "test" lift i just lift them by hands as far as they will go, which is pretty high, do the 3 point actually go the full range when u put the lever to the top?
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
