Posted by Destroked 450 on March 24, 2022 at 21:13:46 from (66.38.93.182):
In Reply to: Reusing head gasket posted by 37 chief on March 24, 2022 at 16:14:22:
I've done it a few times, one was a race engine that had less than 2 hours run time when it destroyed a lifter, metal particles were everywhere so we pulled it part to clean everything and replace the scratched up bearings, while reassembling it one night before a race we realized we had forgot to pick up new gaskets, so we put it together with the old ones, the head gaskets were Felpro and we sprayed some sealer on them and didn't have any issues
The other two were fresh engines, one had a carburetor nut dropped into the intake, it rolled thru a open valve and dropped onto a piston, we pulled the head, removed the nut and bolted the head back on using the same head gasket.
The last was my 5.9 Cummins, we had the head torqued down when I remembered we hadn't checked piston parturition so we had to pull the head back off, The block has been milled so a .010 thicker head gasket was required, that head gasket had cost $165 so we sprayed some copper coat on it and reinstalled it, still holding today.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
