I think 200ma is all the ma scale will read so while I am waiting for it to power down I leave it in the amp scale. It has to do with a good meter something to do with how may zero's with scale it down to. It auto scales it I read .030 on my meter as 30 tho of a amp... 0.175 is 175 tho.
Edit
If I were reading 1amp the meter will show 1.000 if I were reading 1.5 amps it would read 1.500 if I were reading 175ma it would read 0.175. I think this is a 6 digit meter maybe 5, you pay for what you get. I brought this one around 1990 it cost $400. It was hammered into you, you needed a low impedance meter are you could damage the electronics. . I have beat it to death I have always been able to fix it. I have other meters that are more expensive I am conferrable with this one its my first pick out of the bunch.
I like this one for drains my battery is dyeing run time 30min. I have not priced the battery I spec its $300.00.
If I don't find the drain and have to dig in the blind someone else will dig I have got to old to do dash work are under dash work. The hardest part getting folks to LEAVE IT, 99% of the time there is no excessive drain they have to leave it to take the guess out.
This post was edited by Hobo,NC on 03/26/2022 at 04:26 pm.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
