Posted by Gambles on April 03, 2022 at 06:02:54 from (24.246.213.81):
In Reply to: Deere posted by fastfarmall on April 02, 2022 at 16:04:51:
I'm not going to take sides on this issue, because I've been on both. Yes, it is aggravating to have to go to the dealer for a software update. On the other side of the coin, my wife is a software programmer. Good software programmers get paid a very good salary. My wife's salary is proof of that. Somebody has to pay for the work that software programmers do. While Deere is making record profits, there are all kinds of people behind the scene who need to get paid and this is one way Deere is doing it. Also, not all Deere techs know how to run this software. Some customer brought in a combine that had a header leveling problem to the local dealer and their tech worked on it for two and a half days before he gave up. Another tech worked on it for 10 minutes before the computer told him a leveling sensor was bad. Now how do you think the dealer was going to charge for that when it was clearly their tech who wasn't educated in running the software? The customer had it in for other issues and it got added to the customer's bill in the end, that's how.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
