Posted by Carlmac 369 on June 23, 2022 at 05:21:50 from (96.44.113.79):
In Reply to: farmall m hard start posted by Noah Washine on June 22, 2022 at 16:05:00:
Quote: timcasbolt (quoted from post at 23:22:09 06/22/22) [quote="CVPost-used red MN"](quoted from post at 22:52:35 06/22/22) It appears Mr. Tim did not read your statement about
the magneto, crank voltage has minimal affect on a
mag that is working correctly. I am not much of a mag
guy but I do know if you get tangled up in one the
definitely get your attention. I assume you have check
the fire since you did the repairs to it. You end up
putting a new coil on? No matter how slow you turn it
once the impulse lets go it should click over and fire a
spark. Usually a nice blue one that can jump 3/8 inch
or more. Fo you do hear the impulse when you crank
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
