Right size tube for the tire? Do you use a paste type tire lube on the entire rim? I brush a coating of TruFlate/Camel "Stuff" paste on the entire inside of the rim to help let the tube slide around the rim during assembly and inflation. "Stuff", FreyLube, and other tire mounting pastes provide lubrication and most help prevent corrosion/and rusting. I use the paste on the tire beads during installation as well, stays in place and gives better lubrication than liquids. As Majorman posted, inner tube stems are generally off center, so the first thing is to be sure the stem orientation matches the offset direction of the hole in the rim.
I use a chain or cable "fish" that screws to the stem threads run through the rim hole, allowing the stem to drop inside during the installation of the second tire bead (I leave the tubes uninflated during installation). Once the bead is on the rim the fish can be used to bring the stem out through the rim hole. I bounce and shake the tire a few times while pulling the stem into place to help center the stem to the hole. Once the stem seems free in the rim hole, I lightly clamp the stem, near the rim, with a small pair of needle nose vise grips to hold it out for filling. I remove the valve core and use a free flow chuck to inflate the tube to seat the beads. Once the beads are seated, I remove the chuck and let the tube deflate. I do this a couple times to let the tube find its "happy spot", then I put the core in and inflate it, removing the vise grips from the stem once the tube has air enough in it that the stem stays out on its own.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.