Posted by avant 1735 on August 13, 2022 at 19:05:53 from (184.63.81.47):
My tractor hauling trailer had a bearing failure, the grease caught fire. The fire was extinguished before the tires had a chance to burn. I removed the hub and drum, and what was left of the bearings, and replaced the races. My problem is the metal part of the grease seal apparently welded itself to the hub. I have tried to go in with a small chisel to see if I can get under the metal sides of the seal to try and remove it. So far this has not worked. I have ruined a new seal trying to install it this was before I figured out the old seal was still their, but, obviously it won't fit. I ended up buying a new hub and drum, but I sure would like to be a able to use my old one, those babies are expensive. I was thinking of heating up the hub and then applying dry ice to see if I could get the old seal to release. So I am looking for ideas. I really don't want to spend hours with a Dremel tool trying to grind it out. Any suggestions or advice would be greatly appreciated. Thanks
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
