Posted by used red MN on September 11, 2022 at 19:46:47 from (75.73.112.20):
In Reply to: Re: Help with ford 9n posted by CheckpointCharlie on September 11, 2022 at 18:54:56:
Where is the main jet knob on the new carb set? Not being a Ford guy I looked it up. Looks like you should turn it closed lightly seating it and then open it 2 turns. You also must not know much about how a carburetor works. The fuel fitting that is dripping is doing that because the fuel in the tank is higher than the carb. So the gas is acting under gravity and atmospheric pressure to flow or slightly pressurize the fuel line to the carb. Inside the carb is a small chamber that holds the gas it will mix with the air for the engine to run on. The gas in that chamber usually called the float bowl is held at a certain level by a float that activate a needle valve. The fitting you see leaking is feeding that valve, often referred to as the needle and seat. The gas in the float bowl kept at the proper level feeds and opening for the main jet. The knob adjust how much gas can flow out of the float bowl into the main jet to mix with the air going into the intake manifold of the engine. The passage the air flows through and the float bowl are separated areas in the carb. The fuel line leaking and it sucking air at that location is not possible.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Museum Coverage: The Stuttgart Agricultural Museum - by Cindy Ladage. While cold wind was blowing back in Illinois, in Arkansas, daffodils were in bloom, and the Magnolia trees were adorned with fragrant blossoms. Stuttgart, Arkansas was the site of this year's winter Minneapolis Moline Collector's show February 25-27, 1999. The show was held at the Oliver Museum created by Don Oliver, the pioneer of the four wheel drive tractor. Oliver along with Gale Stroh and Kenneth Bull using Minneapolis Moline tractors and parts created what has become known as
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.