Posted by Steve@Advance on September 19, 2022 at 10:17:14 from (47.37.93.96):
In Reply to: 1952 8N BLOCK? posted by NewOldFarmer on September 19, 2022 at 09:33:11:
When the head was off, was it checked for flat and/or surfaced? If the head was warped it will not seal even with a new gasket.
Other factors, the block surface needs to be cleaned down to bright metal, all residue removed, which means removing the studs, if equipped. The bolt holes chased with a tap, the bolt threads cleaned with a wire brush, replaced if showing signs of corrosion or thread damage.
Installing a stud kit will help, if that has not already been done.
The bolts/nuts must be torqued to spec in a tightening pattern, retorqued after first run up to temperature. If the thermostat was not replaced, replace it. Common for a thermostat to be damaged from overheating.
Finally, check the coolant level as the engine comes up to temp. When the thermostat opens it may take more coolant.
Anything is possible, but those do not have a history of heat cracking the head or block. They can freeze crack, then having the head off disturbed something, but do review everything before assuming the worst.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
