Posted by MarkB_MI on October 17, 2022 at 06:38:16 from (174.211.40.250):
In Reply to: Shop Wiring posted by Danny Prosser on October 17, 2022 at 06:10:31:
Most welders use a 50 amp plug. I would wire it for 50 amps (AWG 6) regardless of what the welder requires. That way it's good to go if you get a bigger welder.
You can run a LOT of T8 bulbs on a 15 amp circuit, although if I was installing new fixtures I'd go straight to LED. Assuming 40 watt bulbs, 15 amps at 120 volts should power 45 four foot T8s. Actually, the number is a bit less due to power lost in the ballast and non-unity power factor. But you should be good with 32 bulbs, or 8 eight-foot fixtures.
Don't use a 15 amp breaker for your wall outlets. Use a 20 amp GFCI breaker. One circuit is probably enough for all your outlets, since you seldom will run more than one big 120V tool at a time. But feel free to have more circuits; more is better.
Don't forget you'll need a separate circuit for your (presumably 240V) air compressor.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Brief History of Tractors in Australia - by Bob Kavanagh. After Captain Cook's exploration of the east coast in 1770 the British Government decided to establish a penal colony in Australia. The first fleet arrived in 1788 and consisted mainly of convicts who were poorly equipped and new little of farming techniques. The colony remained far from self-supporting and it was not until the early 1800's that things started to improve. Free settlers started to arrive, they followed the explorers across the mountains and where land was suitable set up farms. T
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.