Posted by Steve@Advance on October 17, 2022 at 06:39:15 from (47.37.93.96):
In Reply to: Shop Wiring posted by Danny Prosser on October 17, 2022 at 06:10:31:
The 30 amp breaker will be for my welder which the plug will be right below the box. Will 10/2 be big enough for that 1 foot run?
Yes, for a wire welder that will work. If you plan on ever using a stick welder, they want a 50 amp circuit on #6.
Also I got some 4 tube drop in ceiling fixtures that use F32T8 tubes. How many of those can I daisy chain together on one 15 amp breaker?
Those pull about 1 amp each. You want to max out a circuit at about 80% of it's rating, so about 12-13 on a 15 amp circuit.
Also how many single recepticles can I put on one? And I'm assuming 12/2 will be good for all of that.
Yes, #12 wire for a 20a breaker. Also consider any outlet near a sink or outdoors needs to be on a GFIC outlet or breaker. How many depends on the load. Resistive loads, like electric heaters, pull a lot! One plug in heater will max out a circuit. So will a compressor or anything with a 3HP motor. Consider putting that on a 240v circuit if possible. Other hand tools, and such draw much less, but consider how many people will be working at one time. If only you, then the load drops.
Overkill is good, better to over build now than to have to come back later and redo!
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Brief History of Tractors in Australia - by Bob Kavanagh. After Captain Cook's exploration of the east coast in 1770 the British Government decided to establish a penal colony in Australia. The first fleet arrived in 1788 and consisted mainly of convicts who were poorly equipped and new little of farming techniques. The colony remained far from self-supporting and it was not until the early 1800's that things started to improve. Free settlers started to arrive, they followed the explorers across the mountains and where land was suitable set up farms. T
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.