Posted by MARK ROBKE on November 27, 2022 at 06:43:31 from (72.4.15.174):
In Reply to: 2140 Starts posted by rusty6 on November 26, 2022 at 19:11:22:
Well I have started many hundreds of unheated truck engines, as well as my own tractors and some for a place I worked at, in cold weather, and I would never give up after 5 seconds of cranking when it was cranking as well as your tractor was doing. I also saw white smoke which indicates to me a little more cranking would have started it. Try cranking for 30-40 seconds before giving up, and see what it does. If it continues to crank at that rpm, and you feel the starter and battery connections with your bare hand (warm is OK-after all it is working to crank a cold engine), it is ok. As long as the cranking RPM is remaining the same steady speed, you are not hurting anything. And always run the engine for a good while to recharge the batteries. If no start, wait one minute and try again. But I think it will start after 30 seconds. I still believe preheating with a block heater is best though, but sometimes that does not happen. And I also believe in the lightest whiff of ether below 30*, especially when it HAS to start. Lastly, please open the shed door before you try to start it. Mark.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
