Posted by Geo-TH,In on December 21, 2022 at 07:39:51 from (174.202.100.153):
It was made from Free scrap materials. This pusher was my prototype pusher. I can remove snow on the lawn and not damage the grass. This pusher floats over uneven surfaces. If I'm not careful the back blade on my Kubota will leave a pile of gravel when the snow melts. This redneck pusher leaves very little gravel.
I even put 3 inch pipe on the back blade. When I hear the pipe come in contact with the gravel I raise the blade to leave the gravel and a little snow behind.
I've never had any luck using the loader to remove snow without damaging the driveway.
My homemade pusher floats up and down plus one end can go up and the side go down.
Please post pictures of your homemade pusher or blade.
Always looking for a way to make a better pusher.
Now I'm ready for the SNOW, just watch and the snow won't show up
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
