Posted by Destroked 450 on January 17, 2023 at 07:46:48 from (174.202.32.199):
In Reply to: Exhaust Mods? posted by LarryBud on January 17, 2023 at 03:56:28:
Just cut the 90 out of the pipe and try it with the exhaust going straight up, then add pipe if needed
I don t like the pipe any longer than necessary to prevent it getting hung into low limbs or low buildings
If you store the tractor inside a flapper isn t necessary
I have 2 tractors with short straight exhaust and no flappers, the exhaust stops just below my eye level in order to work inside my poultry barns, a flapper would hang up on the overhead equipment and after 16 years of farm use I haven t had a issue with water down the exhaust
If the tractor were to set out for long periods of time then yes a flapper or exhaust cover is needed
With the exhaust going straight up there s less chance of it blowing back in your face, unless your doing a lot of idling around
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
