Posted by Destroked 450 on February 10, 2023 at 08:56:59 from (174.238.49.247):
In Reply to: Tractor turbocharger posted by crsutton81 on February 10, 2023 at 06:12:49:
I have that 8.3 engine in my F-800
Take the air intake pipe off the turbo then see if you can wiggle the shaft up and down or in and out
It should have a small amount of up and down for bearing clearance but no in and out, more the 1/8 inch up and down indicates a worn shaft or bearing which would allow the fan blades to rub against the housings
Check the hoses and their connections for holes or loose clamps the would allow boost pressure to escape
Does it have a water cooled after cooler or air to air, if air to air check it for damage to the
And exhaust leak will reduce drive pressure needed to get max boost from the turbo, but these can normally be heard
Adding a boost gage will let you know how the turbo is performing, I use a boost gage to tell me when it s time to change fuel filters
If the air filter or intake is restricted you should be getting excessive smoke under load
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.