Posted by Janicholson on March 23, 2023 at 12:58:37 from (199.17.6.77):
In Reply to: 3 wire gm alternator posted by ford 2600 in maine on March 23, 2023 at 12:36:28:
Simple: The #1 side spade terminal goes to the ACC terminal of the Key. The #2 spade goes directly to the output terminal (6 inch wire with a ring terminal to fit the output stud) Both of these are 12 gauge wires. The output connects to the Amp meter load side through a 35 amp fuse (auto store) The fuse prevents letting the smoke out of things!! That is all that is needed. The output wire should be 10 gauge. The load side of the amp meter is the one not connected to the battery! If the lights are 6v they need changed to 12v (LED is best) If it was 6v positive ground the amp meter needs to be connected with all wires on opposite sides so it reads correctly. The coil should be fitted with a ballast resistor (mid 60s Chevy) if not changed to a 12v no resistor required coil. No diode or other resistor or light is needed! Jim
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.