Posted by dhermesc on April 13, 2023 at 14:33:30 from (12.149.56.202):
In Reply to: Re: Oil in a metal can posted by Janicholson on April 13, 2023 at 13:26:59:
I was at an auction a while back and they had several cases (10?) of old oil in cans. They looked like 1970s maybe 1960s. Quaker State and Skelly where most of them. They sold them by the quart take one or take so many up to the remaining case. Then they would start on the next case. One guy there seemed determined to buy all of them - I just wanted two cans of Skelly because that was the Go to brand on the farm for years. So I ran him up to $20 on every single quart (Quaker State too - just because) - but he outbid me every time - he also paid $21 a quart for every single can. If he had just once let me have a couple cans he would have probably bought the rest for $2 - $3 a quart - wrong crowd for those items and no one else was bidding.
Later the auctioneer asked me about it and got a good laugh out of it. He said he told the seller they were worth something because they almost hauled them to the dump during the preauction cleanup. They ended up getting over $2500 for them.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
