I've been surprised, too. After my Chop King arrived on the property, I wanted to test it out. There wasn't any corn & it just has the 3RN head. Took that off & fed it a few bales. Told my cousin to throw the first one on the feeder, I'll cut & pull the strings. He did that & got it just a bit too close to the feed rollers & there was no getting the twine off safely. The chopper sopped it up like a wet noodle & didn't bog the engine. Barely heard a change in the stack talk. My cousin quipped, that if they'd fit, you could stack those bales two high on the feeder!
Even though they do have a good capacity for a flywheel cut machine, they do have their limits. There are a few spots in the video where you can see the corn is getting close to plugging the feed rolls. Later in the video, the Chop King is cruising right along with the big three row head. The corn looks to be close to 5' tall. Not much of a challenge there.
Last fall a couple pull type Chop-Alls followed me home from an auction. Wanted to see how the appetite compared to the big chopper & fed out a couple bales to the one with six knives. Took the first bale, set it on the feeder, cut the twine, cranked up the 560 & pulled the lever for the feeder drive. It did eat it, albeit slower than the Chop King. The 560D poured out some smoke on that one & did not seem to be the happiest. Think the 806 will go on there next time.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oliver 550 Purchaser Checklist - by Greg Sheppard. Pound for pound the 550 is better than anything I've seen. It has great power for its size and can really hunker down and lug. Classified as a 3-bottom plow depending on soil conditions. I personally don't think it can be beat for a utility tractor in the 40 HP range. They are extremely thrifty on fuel, at least my DSL is. Most drive train parts are fairly easy to get. Sheet metal is probably the hardest thing to
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
