Posted by used red MN on May 12, 2023 at 12:07:52 from (68.46.31.28):
In Reply to: Re: MF 35 (1955) posted by johnbhornor@gmail.com on May 12, 2023 at 10:13:48:
Okay you straightened me out there. Get rough with it! How big of a breaker bar you got? Will a socket fit on there? Looks kind of close the way that chain tab is bent to raise up near it. First get a big hammer like a 2 pounder, smack the head of the bolt as hard as you can as if you want to drive it in. If you have a sledge hammer hold it against the lift arm on the opposite side as a counter weight. You are just trying to move it the slightest bit to break the rust bond. After that get some penetrating oil on there and give it all you got with your breaker bar I would say it should twist loose. If need be put the nut back on and screw it even with the end of the bolt. Get something to set against the nut to protect it from direct hammer blows like a steel plate or an old nut clamped in a vise-grip, then try to pound it out. Heat would be a last resort. Most people do not do it but an occasional drop or two of oil on all those moving joints on a 3 point that are not greaseable is NOT the worst idea ever.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Farmall Story - by Ed Meadors. The year was 1978. Our young family had recently moved to rural Chesapeake, Virginia to a plot of land which would finally allow us to realize our dreams of a huge garden, critters and more lawn and pasture than we would ever use! We needed a TRACTOR; not a riding mower or tractor wannabe, but a real TRACTOR. The answer to our needs materialized in the form of a '44 Farmall A, complete with cultivators, discs, single plow, a 5ft.Woods belly mower and one, mounted spare 9.00x24 rear wheel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.