Posted by 560Dennis on May 24, 2023 at 04:17:50 from (71.72.184.222):
In Reply to: How to remove Hubs? posted by jd2cyl1943 on May 23, 2023 at 14:32:32:
Suggest,tear that down . Drive it straight back ( looks like the hub is not going to move down the shaft with it on that angle ) the mechanism has bound it up on the shaft clean it. Looks like corrosion is binding the hub . Cleaning with brake clean. Get wire brush on a drill and clean up those splines. Or a 80 grit cloth . Clean it good ,get rid of all that rust . Off that axle. Grease or oil it Purchase that cylinder so it pulls the the hub down the axle. As others suggested. Use propane torch to heat up up to expand the hub on the axle will slide better. Use leaded hammer ,brass hammer or dead blow hammer .dont use a sledgehammer it could break that hub whacking on it. Get the rust off down into the splines ,clean it up good. Thats what I think is stopping the removal from the photo .
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.