Posted by crsutton81 on May 29, 2023 at 15:22:17 from (166.182.254.203):
In Reply to: Farmall 140 posted by to30man on May 29, 2023 at 05:41:54:
It's hard for me to determine what part number is what in your picture but, these are from my SA and 140 books. On the end of the axle there is a retaining bolt to hold it all together. Next is a thick dome shaped washer, part #43240 D, then there is either a spacer, part # 47905 D which is used in the instances where there is NOT a sprocket hub installed on that wheel. When a sprocket hub is installed on that wheel, part number 47906 DX, is used as the spacer to gap out the remaining space to install the sprocket hub. It'll have the double d shaped pattern internally to fit tight onto the axle. Are either one of these in place to fit your needs according to if you need the sprocket hub installed or not ? Both are a good quarter inch thick. There is also a large machine washer that fits in behind this. A very small amount of play in an out is ok, but not a quarter inch plus. Hope this helps.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
