Dry dirt will never compact. The friction between the particles will not let the air out.
On the other hand flooded dirt or clay is hard to compact. While it does not have air in the mix it has water. But once the water drains compaction can happen. Clay will compact better than dirt because of all the small particles to fill the tiny voids. The problem with using dirt or clay under a slab is the organic matter in the mix. This will cause it to settle as the organic matter rots away. If you can get some clay dirt mix; most likely red driveway clay; from a pit that is digging well below any organic matter that would be best.
Nothing (in my mind) compacts better than crusher run; 1 inch rocks to dust; limestone. A small dozer can not rip it up.
Sand never fully compacts. Think of a beach. But once you flood compact it that is it. It will not settle more. This and the fact it has little to no organic matter makes it a good cheap fill.
I would clean any disturbed soil out the hole and fill it with sand. Flood it and let drain. Flood it again and let drain. Once you got the hole filled cover the dirt sand with a fabric and put down a layer of limestone.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
