For the oil bath filter, go buy a gallon of 30wt NON-detergent. The detergent oils are made for modern engines and retain particles in suspension until the oil is changed.
Non-detergent oil will allow the particles captured during run time to sink to the bottom of the little canister. If you are careful, you can pour off the relatively clean oil above, and then scrape out the dirt from the canister, and then put the oil back in. With modern detergent oils the particles are held in suspension.
You don't need to clean it every 8 hours of run time, but consider the work conditions, and hours. If it's very dusty, every 25 hours of run time would be ok. If it's not driven into a lot of dust you might get away with 40 hours run time. It's not a set time, but it's how dusty the conditions are.
You used to be able to buy a water canister pre-filter. There is an attachment to the intake on the left side of the hood which sticks out, and has a glass jar below it. There is a turbine effect for the intake air, and particulates are dumped into the water jar, which then can be removed by just tossing out the water, and refilling the jar. It's hard to see behind the loader arm, but my Ford has the water jar pre-filter. Don't know if it's still avail anywhere, maybe call around to tractor junk yards and ask for it. This makes seeing the amount of dirt, and changing it out very quick and easy.
Another way is called the snorkel intake. It's basically a long tube that sticks out the side of the hood side and goes up 3-4 feet with a little hat or sock on top. The air more than 8' off the ground is usually much cleaner than right about the normal intake area. I haven't seen a snorkel intake for a while, but with some exhaust pipe, you could have the shop bend up what's need and make your own.
This post was edited by docmirror on 06/13/2023 at 11:46 am.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
