Posted by redforlife on July 02, 2023 at 08:14:10 from (174.213.212.21):
In Reply to: Re: implosions posted by john in la on July 01, 2023 at 22:26:30:
So, your saying tube won't pop basically because of no ballooning effect. I'm following you.
But what if there was a ballooning effect somewhat reversed. When the valve stem is pushed into its hole, the tube is actually beginning to collapse in on itself. I'm not sure how things would go after that. If a run over by steam roller affect begins to happen, the rising air pressure would constantly be restricted to a smaller space, causing ballonage to that one area. As a result, the tube would blow in that one area. The air might not escape the main tire at that point (as in can't leave the valve stem hole because its above that), but nothing more would really happen because at that point nothing is really between the air and the water.
I guess it'd come down to weather the steam roller effect happens. I myself am unsure what would happen there. I could see the beginning phase of it happening. Not sure if it would continue until point of tube blowing. The rim holds the tube in a somewhat fixed position. Not sure if that is enough of a fixed position to allow completion of the steam roller effect. Would make a difference in that regard if the tire was horizontal or vertical. Being vertical would allow the tube to completely collapse in on itself at the bottom, beginning the chain affect. Then the question would be, what the collapsing would do once it reached the top of tire. Whether it would stop collapsing the tube in on itself, or if it would continue collapsing the tube against the air bubble inside. Saying it like that, almost makes me believe the collapsing would stop at some point, but I don't know that for sure.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.