Posted by Geo-TH,In on September 22, 2023 at 05:16:35 from (65.189.196.95):
MarkB suggested adding Marvel Mystery Oil to my gasoline to prevent valves from sticking.
MMV was popular decades ago. I found a 5 gallon can with a little MMV in it.
This sounds like a good idea, especially if we have an antique tractor that sits more than it runs.
I'm willing to try anything, 2 cycle oil, ATF, seafoam or diesel to gas or to crankcase oil. What snake oil do you use?
Ethanol absorbs moisture. Most people hate ethanol. Would adding ethanol to the oil help remove condensation inside the engine. I'm just brainstorming.
What do you add to your gas or oil to prevent valves from sticking?
I don't want to have sticky valves again.
I think in the future, I'll have to put the old girl to work or let it run at more than an Idle to warm the engine up.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
