Posted by thomas h kwapiszeski on September 26, 2023 at 16:20:37 from (99.162.0.124):
WE HAD OUR 27V IH MOWER MOUNTED ON A FARMALL MODEL M. WE CUT HAY AND MOWED THE SHOULDER OF THE ROAD IN 4TH GEAR. YOU HAVE TO KEEP YOUR GROUND SPEED FAST ENOUGH TO KNOCK THE CUT MATERIAL OFF THE BAR. TOO SLOW AND IT WILL PLUG. WE ALWAYS USED SERRATED SICKLE SECTIONS AND LEDGER PLATES. ALWAYS BUILT OUR OWN SICKLES AND REPLACED OUR OWN LEDGER PLATES. THE WERE SMOOTH SICKLE SECTIONS AVAILABLE BUT DAD ALWAYS SAID THE SERRATED WERE BETTER. THE 7 FOOT SICKLE BAR COULD ALSO BE 'tipped' UP OR DOWN FROM THE HORIZONTAL WE KEPT OURS TIPPED BACK 'up' TO KEEP FROM CUTTING IN TO GOPHER MOUNDS SO BAD. NOT A GOOD IDEA TO CUT WITH WET OR MUDDY GOPHER MOUNDS AS THIS WOULD CLOG BETWEEN THE LEDGERPLATES. WHEN WE GOT DONE WE STUCK THE SICKLE BAR IN THE POND AND RAN IT FOR A WHILE. THAT WOULD HELP CLEAD THE DIRT OUT FROM THE BOTTOM OF THE LEDGER PLATES. LPTS OF MEMORIES!
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
