save yourself a lot of work and take one or 2 of those hog panels. cut out the 5th from the bottom (if I remember) horizontal bar between every second upright. you can look at it and see what bar needs removing. about 1 ft off the ground what ever bar that is. If you think you can get away with it you can do 2 ,1on top of each other if the hole would otherwise be to small. I then tie 2 of them together with a tear drop hook. not sure that is the right name for it. wrap around the bale and hook together again. I like the 4 ft panel best but have used 36 inch but sheep will climb over it sometimes. I have used the cow panels but they can get there head in all the holes and get caught. pig panels are so close together at the bottom they can't get there head in except where you cut out the bars. You can leave it foot away from the bale or even 2 feet away. then just peel around and let it fall. it is flexible enough that they will push it a bit to reach the hay. I found that the best sheep feeder ever and I built a few different ones. always put the bale on end. when they have eaten most of it the panels are so easy to just un hook and move to the next bale.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.