Almost all electronics gets better with the next generation, TVs included. So yes it will be better. However the antenna and down lead are very important components as well. A lot of digital TV channels are in the UHF band but not all. Some have even remained at their original channel. As others have said there is no such thing as a digital antenna, so dont fall for that sales pitch. Pick the antenna with the highest gain. Usually dBi is the unit of measure. If all your channels are UHF and emanating from the same direction, then a good high gain UHF antenna should treat you well. IF some are VHF and or emanating from different directions, a second antenna may be needed.. I would run nothing less than RG 6 or better yet RG 11 from the antenna to the TV. If you are having signal level problems, I install a preamplifier at the antenna. The amplifier will boost your RF levels without amplifying the noise as it would at the bottom of the coaxial lead. The result will be better signal quality.
Most new TVs will have ROKU channel as part of the TV. A ROKU stick shines when you are traveling. You can just take it with you and plug it into a HDMI port and have all your streaming channels available. BTW you need a high speed internet connection over 4 meg or even better 20 meg download speeds for the ROKU work properly.
Most of my working life, I have been working with multi frequency/channel delivery systems, antenna design as weill as a vast knoowlodwwwge base in the broadcast TV and FM radio business.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
