Yup he did and I was just pointing out that with setting for 8-10 years there could be a lot more possibilities than just the resistor.We drove pretty excusively Chrysler vehicles till the mid 80's when dad could buy used land yachts from his cousin cheaper than he could buy other cars on lots. So he then started driving the big Buick 225's Yes we had a couple resistors go bad in about 25 years of Chrysler vehicles and that was it. Those Buicks were not all that grst to me just a lot of transmission work and ignition problems with distributor caps. Got so we could change out the Transmissions in about 2-2.5 hours from pulling the old one and driving away with the new one in. My brother would start on one end and I would work the other end. Would push the tail up to get the cros memeber out and let it down on my chest then slide it out put the nwe on on my chest and slide it up there so he could start a couple bolts then with the 2 bottom ones in would push up and get the cross member in and was down hill from there.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
