Posted by caterpillar guy on October 20, 2023 at 03:48:13 from (47.26.14.222):
In Reply to: disk blades posted by avant 1735 on October 19, 2023 at 19:31:47:
Blades are a crap shoot anymore. For the nuts and such clean them up as best you can. with a wire brush and then with a file clean up any scars on the threads. this will make removal much easier and assembly much better with some grease on the threads going on and an impact wrench you can tighten them sufficiently. Though you want a 1 inch impact not your little 1/2 inch one. You can use that to start but the big one to finish the job. No wrestling match with pipe wrenches to get them loose and then tight again. We changed the ones on our Sunflower disc last spring. That one inch impact was the cats meow for that when it quit turning we would hit the back end of the shaft with the sledge and it would go some more. Never did any come loose since either. Biggest problem was getting the holders for the bearing to fame aligned.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
