Posted by gwayne1962 on October 23, 2023 at 11:46:26 from (150.220.11.98):
I bought my 560 a little over a year ago...seller did not have alot to say about it...bought it for a good price and have been using it around the farm mainly for moving hay and brush hogging. The most recent issue that I have, is when I am pulling up with the front fork loader and sticking the bale....once the fork is in, and i try to take the 560 out of gear, the shifter is stuck in gear...
This past weekend i was moving hay to a new holding area and when i would try to push the bales together..once I had the bale down and up against the bale on the ground..same thing...could not get the tractor out of gear.....sometimes I could raise the bale up high and the tractor would move a little and could shift it out.
But when I go back to get the next bale out of field...if I did not pull the shifter out of gear before the loader was all the way in the bale same thing...could not pull shifter....I could shut the tractor off and get it out of gear...but sometimes it was a hard pull to get shifter to move out of gear, which didnt seem good either.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
