Posted by super99 on October 26, 2023 at 17:33:08 from (172.242.17.27):
When I pull my Oliver 4240 3 bottom plow I have to move the drawbar 2 holes to the land side to make the plow run in the furrow, I am trying to move the furrow wheel on my Oliver 1550 in so I dont have to move the drawbar when plowing. I have operators manual but it doesnt say anything about where to set rear tractor wheel. When the drawbar is straight it measures 30 inches from center of drawbar to inside edge of the tire When I move the drawbar 2 holes to the right, it measures 25 1/2 inches to the tire. The plow measures 28 inches from center of drawbar to the furrow wheel
I think I need to move the tractor wheel in about 5 inches to make everything line up. Anyone know where the furrow wheel should be set to line everything up? The wheel hub U bolts are rusted in tight and dont want to loosen up so I can move the hub.
I got the wheel off tonight and will try heat and beat again tomorrow .
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
