Posted by used red MN on December 05, 2023 at 12:02:28 from (72.21.227.18):
In Reply to: Re: John deere 4020 LP posted by greasemonkey9519 on December 05, 2023 at 09:33:21:
The reason for mentioning the areas in my post is that there are probably still some old timers that know about servicing propane fuel systems in those areas. Where you are finding service for propane systems will probably be limited to forklift or other machines that are run inside were the fumes are a concern. A gummy thick oil drops out of the LPG and is one enemy of propane carburetion. Also holes in the diaphragms are another common trouble. One thing that is often neglected on tractors is the front wheel bearings. If you got one of them to the point where you are going to use it at least jack up the wheels and shake them to check how loose they are.Then spin it and make sure it does not sound rough. If it passes those tests it will probably be okay for a bit. It would be a good idea to eventually go through them all and repack them. Not sure if anyone else mentioned this but an I&T shop manual would be a good purchase as well. See the top selection in the link. Unless you want to spring for the Deere manuals.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oliver 550 Purchaser Checklist - by Greg Sheppard. Pound for pound the 550 is better than anything I've seen. It has great power for its size and can really hunker down and lug. Classified as a 3-bottom plow depending on soil conditions. I personally don't think it can be beat for a utility tractor in the 40 HP range. They are extremely thrifty on fuel, at least my DSL is. Most drive train parts are fairly easy to get. Sheet metal is probably the hardest thing to
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
