Tractor Talk Discussion Board |
Re: Piston Rings
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RAB on February 03, 2002 at 03:13:03 from (195.93.49.182):
In Reply to: Piston Rings posted by Steve on February 02, 2002 at 08:55:57:
What they mean is don't try to run it in on tick over or light duties. In these cases the bores can glaze instead of the rings bedding in properly resulting in excessive blow-by. Often a lower grade or special 'running-in' oil is recommended to prevent this. The oil will allow the rings to scour the bores but won't be in the engine long enough to degrade sufficiently to cause bearing lubrication issues. Dont use a 'super synthetic' oil or wear reducing additives or similar until an engine is run in properly and completely, or it may not ever be run in - and that could mean high oil consumption for a long time! Conversely the advice doesn't mean run it flat out. Just run it under a fair load at reasonable RPM and you shouldn't go wrong if everything has been done according to service specification. The main trouble areas when re-ringing are 1) wear ridge in the bores so the new top rings strike it causing breakage(often stepped rings are used to overcome this) and 2) too much side clearance between ring and groove which can lead to oil-pumping. Both these will probably result in premature re-overhaul to replace pistons and liners or for a re-bore.
Follow Ups:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|