|
Tractor Talk Discussion Board |
Re: Re: Re: Crank Question
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by G Taylor on February 06, 2002 at 18:52:13 from (64.10.143.173):
In Reply to: Re: Re: Crank Question posted by RAB on February 06, 2002 at 13:25:44:
Missed the point. If any welding is going to be done, this is the time to add more metal on three sides of the rod journals & then grind in some more stroke. It's done all the time.
Properly done, reliability is not significantly affected. This process will also bring the journal back up to stock size.
Just tossing an idea out there as this would be the time to add some stroke instead of wishing later he had when the opportunity was there.
Crank failure after rebuilds occur because someone left a stress riser from a substandard machining, too tight/loose clearances or the crank/rod were already metal fatigued prior to "rebuilding".
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
