Tractor Talk Discussion Board |
Re: oil holes in rod bearings
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hal/WA on February 21, 2002 at 12:38:49 from (208.8.194.45):
In Reply to: oil holes in rod bearings posted by jimbo on February 19, 2002 at 08:49:18:
Jimbo, if you look at one of the rods with the bearing shell out, is there a hole for a hole in the bearing shell to line up with? If the bearings fit otherwise (right clearance with plastigauge), and the problem is in fact caused by there not being a hole, then why couldn't you drill a small hole in the bearing shell at the right place? Some older engines used a kind of jet from the big end of the rod to spray the wrist pins. Maybe your bearings were improperly made or maybe the oiling hole varied in location. Hope this helps.
Follow Ups:
Home
| Forums
Today's Featured Article -
Museum Coverage: The Stuttgart Agricultural Museum - by Cindy Ladage. While cold wind was blowing back in Illinois, in Arkansas, daffodils were in bloom, and the Magnolia trees were adorned with fragrant blossoms. Stuttgart, Arkansas was the site of this year's winter Minneapolis Moline Collector's show February 25-27, 1999. The show was held at the Oliver Museum created by Don Oliver, the pioneer of the four wheel drive tractor. Oliver along with Gale Stroh and Kenneth Bull using Minneapolis Moline tractors and parts created what has become known as
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|