Tractor Talk Discussion Board |
Re: Lugging a Gasoline engine
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jon Hagen on April 14, 2002 at 10:32:23 from (63.160.195.124):
In Reply to: Lugging a Gasoline engine posted by FM on April 14, 2002 at 09:31:49:
Gear up and throttle back works for gasoline engines too as long as you don't overdo it. I would not run at less than 50-75% of full rpm if pulling a mid to heavy load. Kind of a rule of thumb is if you gear up and throttle back,you should be able to open the throttle and gain full rpm in a short time. If you open the throttle and gain rpm slowly or not at all you are lugging/overloading it too much. The throttle back gear up advice is for water cooled engines. Many air cooled engines need full rpm to get enough cooling.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|