Tractor Talk Discussion Board |
Re: Re: Lugging a Gasoline engine
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by G Taylor on April 15, 2002 at 02:28:50 from (64.10.143.213):
In Reply to: Re: Lugging a Gasoline engine posted by Ron on April 14, 2002 at 12:34:46:
Sorry compression ratio is also the expansion ratio. That's why a high compression engine can extract more energy than low compression from the same btu's of fuel. Long stroke or short stroke doesn't matter, if the compression ratio is only 4 to 1 the burning gases expand less than 4 times before the exhaust valve vents pressure. So a seven to one engine can let the burnt high pressure gases push up to 7 times expansion. This is why steam engines had compound low pressure cylinders added for more efficiency after the high pressure cylinders. Sometimes turbines where even added after the piston engines to make full use of the pressure vented from the piston cylinder.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|