|
Tractor Talk Discussion Board |
Re: antother 3 point hitch question
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dell (WA) on May 14, 2002 at 02:04:23 from (198.81.16.173):
In Reply to: antother 3 point hitch question posted by linhorst99 on May 13, 2002 at 22:56:10:
Linhorst..........What you are experiencing is the 9N's hydraulic draft control working. The draft control was designed for plowing and not for height position control. It could also be a hydraulics/PTO issue because the hydraulic pump stops pumping every time you clutch and without hydraulic pressure, the weight of the hog will drop the hydraulic lift. If you had asked this question on the N-Board, you would have been bombarded with testimonials about the wonderfully effective $80 externally installed "Zane Thang" for hydraulic position control. Other than the Zane Thang, many N-Tractor brushog users use height limiting chains. The chains take the load off the hydraulics and set the cutting height. The chain collasps when you raise the hydraulic lift to go over obsticals and then when you lower your hog, it returns to your pre-determined cutting height. Also highly recommended that you use on Over Running Coupler (ORC) on your PTO. It prevents all that rotory inertial engergy from backfeeding into your tranny and continuing driving your tractor when you clutch to slowdown to go around the corner of the barn, fencepost, creekbank, irrigation canal, wifes car (don't ask). $60 cheap. Also prevents expensive tranny noises...........respectfully, Dell the self-appointed ORC safety preacher
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
