|
Tractor Talk Discussion Board |
Re: Re: Re: Re: Trailer safety
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jim in Michigan on June 28, 2002 at 12:13:43 from (12.34.47.41):
In Reply to: Re: Re: Re: Trailer safety posted by evielboweviel on June 28, 2002 at 10:05:07:
I have a home made trailer made from a house trailer frame, we took the cut off extra parts and added it to the frame, I also had a old 8x17 trailer here made from 2 inch steel tube, the old 8x16 trailer is now mounted on top of the house trailer frame, it has 3 axles with mounts for a fourth one. My only problem is it is too high. So now I am going to move the axles to above the springs so that it will be lower, as it is I have hauled 5 tons with no trouble. I pull it with either my 81 ford 1 ton 4x4 or my 86 ford half ton 2 wheel drive, the half ton has a straight 6 engine and a 4 speed trans and it handles the trailer better then the 1 ton with a 400 and a auto,,,Jim
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
