|
Tractor Talk Discussion Board |
Re: Good Pole or Steel building.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ShepFL on August 06, 2002 at 11:39:24 from (155.14.78.39):
In Reply to: Good Pole or Steel building. posted by MDJON on August 06, 2002 at 08:02:26:
MDJON - I put up a 30x60x14 Millenium Steel bldg. They are sold out of Tallahassee, FL. Bldg is actually from Olympia Bldg. located in PA. This bldg. was a pain to assemble due to inadequate dwgs. and and limited text to support them. While I like my shop I would look at Steel Building Systems, or Butler Bldgs. They have the flanges welded to the uprights and makes assy. much quicker. They also include bolt on bracing between the girts and purlins which ease assy. If I ever decide to do this again I suggest the following:
a) ridge cap ventilation entire length of bldg.
b) 3 or 4 block stem wall then affix bldg atop this. Permits taller door at less cost.
c) Add 1 drive thru door on 1 side
d) rain gutters with 2-3 down spouts per side Below is a link to some pics of my shop. It is now finished and I have just failed to include updated pics. 2 notes for pleasing visual effects
MAKE SURE TO PREDILL WALL SHEETS B4 ASSY!!
ALSO RUN STRINGLINE DOWN RIDGE CAP TO MAINTAIN STRAIGHT SCREW LINE. Drop me a line if any questions.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
