Tractor Talk Discussion Board |
Re: Re: Farmall H with John Deere 45 Loader
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ed on October 03, 2002 at 06:11:09 from (198.185.163.7):
In Reply to: Re: Farmall H with John Deere 45 Loader posted by john on October 01, 2002 at 18:17:22:
It's the same as an M. You'll neet to create the whole hyd circuit - pump, hoses, Hyd tank, and control valves. The pump goes behing the distributor - be careful to mark everything as you will have to retime the engine. For the tank many farmers use the old belly bump - tap a line in the bottom for the suction and tee a return line in where the breather cap is. For the control valves most farmers have welded a piece of flat metal where the right light goes on the steering collum. Bolt the control valve(s) to this and connect it all up with hyd hose. Becareful when hooking up the hoses to make sure the fluid is moving in the correct direction. Bottom of tank to suction on the pump - pressure port on pump to in port on the control valve - out port on valve to tee with breather on tank. If you add a second valve out on first valve goes to in on second valve and so on. If the loader has control valves hook up in the same manor. Single acting valves should be last in line - closest to tank. All valves are open center valves - closed center valves will rob too much hp amoung other bad things. A closed center system dosen't make very much sense on a small tractor. Be very careful - if you hook it up incorrectly you'll break the timing gears. Once this is all done you can then connect your implements to the working ports on the control valves - quick disconnects make it much easier to change implements. Good luck
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|