Tractor Talk Discussion Board |
Re: International 1466 Diesel Engine
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steven@nd on October 22, 2002 at 11:00:33 from (165.234.131.150):
In Reply to: International 1466 Diesel Engine posted by Walt on October 22, 2002 at 04:16:29:
That is fairly low hours on a 400 series IH engine. Our 1086 had 7500 hours on it when we overhauled it, due to low oil pressure. It needed only bearings but we went all the way while we were in there. It is recommended to put in new rod and main bearings around 4000 hours, but most run 5000 or 6000. If it doesn't have a water filter, put one on it or change coolant every year. That engine will cavitate and destroy itself if the pH of the coolant is off. Rated at 133 hp on the PTO and 118 hp on the drawbar. However, our 1086 has the DT414 engine and is rated the same as yours, but puts out 150 on the PTO.
Follow Ups:
Home
| Forums
Today's Featured Article -
A Brief History of Tractors in Australia - by Bob Kavanagh. After Captain Cook's exploration of the east coast in 1770 the British Government decided to establish a penal colony in Australia. The first fleet arrived in 1788 and consisted mainly of convicts who were poorly equipped and new little of farming techniques. The colony remained far from self-supporting and it was not until the early 1800's that things started to improve. Free settlers started to arrive, they followed the explorers across the mountains and where land was suitable set up farms. T
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|