Tractor Talk Discussion Board |
Re: replacing pto seal on 460 IH
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dennis Benson on November 24, 2002 at 16:19:55 from (152.163.188.71):
In Reply to: replacing pto seal on 460 IH posted by Terry on November 23, 2002 at 18:02:13:
I'm not familiar with the tractor, but if you have the replacement seal you can tell if you will have to remove the plate. It may be easier to remove the plate, or you may be able to put a sheet metal screw into the old seal and pull the seal with something like a claw hammer. It might be easier to put the new seal in with the plate removed, but you could find a piece of pipe that will slip over the PTO to drive the seal in straight. I had an IH 464 in the 1970's that used hytran fluid, but you should check that with a manual.
Follow Ups:
Home
| Forums
Today's Featured Article -
Show Coverage: Godfrey, Illinois Country Days - by Cindy Ladage. Except for last fourth of July's Old Gold show in Springfield, Illinois, I don't remember when it was so hot. Nevertheless, the heat didn't keep vendors and visitors alike from enjoying the third annual Country Day's Event. Jane Elliott said the event was originally a one man show. "Barry Seiler, owner of Country Town Farm Supply store used to invite people up to the Johne Deere store. He would give hats and a free meal for everyone that brings a tractor." Elliott said while this
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|